ESD2401 | Speed Control
12V DC | 24V DC • Standard Force Unit
- Isochronous operation
- Idle Control
- Lower Gain Adjustable
- Anti-Windup Circuit (Diesel or Gaseous)
- Hard Potted for Reliability
$295.49
International orders welcome! Call or email for shipping estimate
12V DC | 24V DC • Standard Force Unit
- Isochronous operation
- Idle Control
- Lower Gain Adjustable
- Anti-Windup Circuit (Diesel or Gaseous)
- Hard Potted for Reliability
The ESD2400 Series are all-electronic devices designed to control engine speed quickly and precisely in response to transient load changes. The ESD2400 will control a wide variety of engines in an isochronous mode when connected to a proportional electric actuator and magnetic speed sensor. The ruggedly built ESD2400 is designed to withstand the engine environment. Light-Force variations are available which are optimized for low current actuators. The ESD2400 Series speed control unit is hard potted and rugged enough to be placed in a control cabinet or engine mounted enclosure with other dedicated control equipment. If water, mist, or condensation may come in contact with the controller, it should be mounted vertically. This will allow the fluid to drain away from the speed control unit.
ESD2401 – GAC speed control unit
The GAC ESD2401 is an all-electronic speed control unit that keeps engine speed steady and reacts quickly to changes in load. Used with a proportional electric actuator and a magnetic speed pickup, it provides isochronous speed control for a wide range of engines. The unit is hard potted, protected against transient and reverse voltage, fungus-proof and corrosion-resistant. It can be installed in a control cabinet or in an engine-mounted enclosure, in any position (vertical preferred). Gain, stability, idle and speed are adjustable, and an optional external 5K speed trim is available. Available for 12 V and 24 V systems, with idle control and an anti-windup circuit. ESD2401: Standard Force version. Important: the engine must have an overspeed shutdown device that works independently of the governor.
Specifications
| System voltage | 12 V and 24 V (references -12 and -24) |
| Operating voltage, 12 V system | 8 – 20 V DC |
| Operating voltage, 24 V system | 16 – 32 V DC |
| Protection | Transient and reverse voltage protected |
| Polarity | Negative ground (case isolated) |
| Power consumption | 60 mA continuous, plus actuator current |
| Maximum actuator current | 10 A peak at 25 °C (77 °F) |
| Steady-state stability (isochronous) | ± 0.25 % or better |
| Speed range | 1 kHz – 7.5 kHz |
| Drift with temperature | Typically < ± 0.5 % |
| Speed trim range | ± 250 Hz typical |
| Idle range | 500 – 5000 Hz (with trim pot installed) |
| Speed sensor signal | 1.0 – 50.0 V AC RMS |
| Ambient temperature | -40 to 85 °C (-40 to 180 °F) |
| Relative humidity | Up to 100 % |
| Vibration | 5 G, 2 – 500 Hz |
| Finish | Fungus proof and corrosion resistant |
| Construction | Hard potted |
| Weight | 340 g (12 oz) |
| Mounting | Any position, vertical preferred |
| Recommended fuse | 15 A in the positive battery lead |
| Wire size | 16 AWG (1.3 mm²) or larger |
Source: GAC (Governors America Corp.) ESD2400 Series data sheet.
Additional information
| BRANDS | GAC |
|---|---|
| Volts GAC | 12V, 24V |
