EVR20F-11211-N00 | Forced Circulation Pump Heater

Hotstart

  • Pre-Heat: Diesel and Gas engines, construction equipment, trucks, marine and industrial applications
  • HOTSTART’s EVRHEAT Series 20 engine heater features a debris-resistant forced circulation pump, indicator lights to display heater operation and temperature status
  • Heating Fluid: Engine Coolant, Water, other – No pump needed (thermosiphon principle) | Cut the hose to the required length based on your engine size | 4 foot power cord | 5/8″ hose nipples.
  • Adjustable 180° swivel inlet hose barb, accommodating plumbing requirements in confined areas and allowing for easier field retrofits.
  • Engine Displacement: Up to 15 L (915 CID)
  • Volts: 120v – kW: 1.4 – AMPS: 12 – 60Hz
  • Primary Temperature Control Set Points 110°F (43°C)

$700.00

The EVRHEAT Series 20 has been designed and built with efficiency, versatility, and reliability in mind. Indicator lights on the operator display show current heater operation and temperature status, so you can be sure your engine is always ready to start. At-a-glance, users can see power is on, the element is energized, and the pump is circulating heated coolant. The integrated controls and sensors monitor the status of the heater and coolant; if an air pocket or other fault is detected, the heater deactivates power allowing for users to safely resolve the fault and reset the heater. Installation of the EVR20 is simplified with an adjustable 180° swivel inlet hose barb, accommodating plumbing requirements in confined areas and allowing for easier field retrofits. The EVR20 applies heating power precisely, adjusting the output wattage in response to fluid temperature changes as little as 1 °F. This results in more uniform heat to the engine and eliminates nuisance low temperature alarms. When compared to thermosiphon alternatives, the EVR20 is more efficient in its operation, providing up to 45% energy savings over standard thermosiphon heaters. HEATING INFORMATION Primary Heating Water Engine Coolant / Water Primary Heat Power 1.65 kW POWER SPECIFICATIONS Power Sources AC, Single-Phase, 60 Hz Voltages 120 POWER CONNECTORS NEMA Plug Unterminated cord TEMPERATURE CONTROL Primary Temperature Control Set Points 110°F (43°C) MOUNT TYPES Bracket INLETS / OUTLETS Inlets 0.625” hose barb (15.9 mm) 0.75″ hose barb (19 mm) Outlets 0.625” hose barb (15.9 mm) 0.75″ hose barb (19 mm)

SKU: EVR20F-11211-N00 Category: Tags: , ,
BRANDS

Hotstart

EVR20F-11211-N00 | EVRHEAT Series 20

  • Pre-Heat: Diesel and Gas engines, construction equipment, trucks, marine and industrial applications
  • HOTSTART’s EVRHEAT Series 20 engine heater features a debris-resistant forced circulation pump, indicator lights to display heater operation and temperature status
  • Heating Fluid: Engine Coolant, Water, other – No pump needed (thermosiphon principle) | Cut the hose to the required length based on your engine size | 4 foot power cord | 5/8″ hose nipples.
  • Adjustable 180° swivel inlet hose barb, accommodating plumbing requirements in confined areas and allowing for easier field retrofits.
  • Engine Displacement: Up to 15 L (915 CID)
  • Volts: 120v – kW: 1.4 – AMPS: 12 – 60Hz
  • Primary Temperature Control Set Points 110°F (43°C)

Technical information

HOTSTART EVRHEAT Series 20